Two-W Livestock Equipment - Rodeo Equipment

The Rodeo equipment is constructed primarily of 2 Inch 13 gauge high tensile tube, with heaver pipe being used at critical stress points. The TWO-W line of Rodeo equipment is designed to connect to the 400 or 500 Series equipment.

Two-W Rodeo Equipment has been used at:

• "Calgary Stampede" Calgary, Alberta (Rodeo & Cattle Pens)
• "Canadian Finals Rodeo" Edmonton, Alberta (Rodeo)
• "Pacific National Exhibition" Vancouver, British Columbia (Rodeo * Cattle Pens)
• "Northern International Livestock Exhibition" Billings Montana (Rodeo)

All the Rodeo equipment is coated with the Two-W unique grey powder paint system and then baked for a long lasting finish that stands up to the most severe climate and weather conditions.

	Bucking Chutes Description: Two-W Bucking Chutes are constructed of Primarily 2" outside diameter 13 gauge high tensile steel. Chutes are available in Left or Right hand. The common system has 3 left and 3 right. These Two-W Bucking Chutes meet all the standards set by the various associations like the Professional Rodeo Cowboys Assoc. and the Canadian Rodeo Cowboys Assoc. Bucking chute doors are pre-loaded. This means when you open the plunger latch, the door actually springs open. This increases the safety to the chute operator and the contestant as well. All the Bucking Chutes come with a 4 foot wide catwalk on the back side. Bucking Chutes can be ordered with either "Elevators" or "Skids". The Elevators are for permanent facilities and the Skids are for portability like in an indoor rodeo in a skating rink.
	Bucking Chute Corners Description: Two-W Bucking Chute Corners are constructed of Primarily 2" outside diameter 13 gauge high tensile steel. These Two-W Bucking Chutes meet all the standards set by the various associations like the Professional Rodeo Cowboys Assoc. and the Canadian Rodeo Cowboys Assoc. This corner is designed to help make a secure 90 degree corner usually found between the back penning and the bucking chutes. This increases the safety to the workers and the livestock.
	Block Doors Available Sizes:32 Inch and 38.5 Inch (Measurements are to pin centres) Description: Two-W Block Doors are constructed of Primarily 2" outside diameter 13 gauge high tensile steel, with heavier pipe used where required in stress points. These Block Doors meet all the standards set by the various associations like the Professional Rodeo Cowboys Assoc. and the Canadian Rodeo Cowboys Assoc. You specify 400 or 500 series attachments for ease on connecting to your equipment. Use:This Block Door is used to control livestock in narrow alleys.
	Timed Event Chute Description: Two-W Standard & Classic Timed Event Chutes are constructed of 1 Inch square heavy gauge high tensile steel. These Two-W Chutes meet all the standards set by the various associations like the Professional Rodeo Cowboys Assoc. and the Canadian Rodeo Cowboys Assoc. This chute has an access gate on the side for the operator to access the alley. And the end gate is an easy to operate drop gate.
	Timed Event Chute Extension Description: Two-W Chute Extensions are constructed of 1 Inch square heavy gauge high tensile steel. These Two-W Extensions meet all the standards set by the various associations like the Professional Rodeo Cowboys Assoc. and the Canadian Rodeo Cowboys Assoc. This chute has an easy to operate drop gate.
	Chute With Chute Extension Description: Two-W Chutes with Chute Extension are constructed of 1 Inch square heavy gauge high tensile steel. These Two-W Chutes meet all the standards set by the various associations like the Professional Rodeo Cowboys Assoc. and the Canadian Rodeo Cowboys Assoc.